Rayher mould holder for latex 3D full moulds, 24 × 21 cm

Rayher mould holder 34217000 – holds latex full moulds while pouring

The Rayher mould holder for latex full moulds (art. no. 34217000) is an accessory for pouring into latex casting moulds. You place it on a container filled with water and hang the latex mould in it. This keeps the casting compound contained and the mould hangs securely while you fill it.

The holder measures 24 × 21 cm and has a cut-out of ø 8 cm. It is intended for the Rayher latex full moulds Bird (34215000) and Garden Gnome (34216000).

Using the mould

Rayher recommends the holder for easier pouring of the latex full moulds. There are two ways to hold the mould:

• Place the holder on a container filled with water and hang the latex mould in it.
• Alternatively, push the mould through the opening of the holder and place the holder plate on a larger container.
• Choose a container so that the mould hangs freely and the plate rests securely before you pour in the casting compound.

Which moulds fit?

The cut-out is ø 8 cm, so the holder only suits small moulds. Rayher specifies it for the latex full moulds Bird (34215000) and Garden Gnome (34216000). Larger latex moulds cannot be pushed through the opening. Check before buying that your mould is one of these.

Rayher mould holder 34217000 product details

• Manufacturer: Rayher, art. no. 34217000
• Dimensions: 24 × 21 cm
• Cut-out: ø 8 cm
• Suitable for: latex full moulds Bird (34215000) and Garden Gnome (34216000)
• Contents: 1 piece in a retail bag

You will also need: a Rayher latex full mould (Bird 34215000 or Garden Gnome 34216000), a container the mould can hang in, and casting compound