Cernit Cloud Silicone Mould for Polymer Clay and Epoxy Resin

Cernit Cloud Silicone Mould – flexible motif mould for modelling and casting

The Cernit cloud silicone mould is a motif mould for polymer clay and epoxy resin. You can use it to make small cloud motifs for jewellery, accessories, table decorations or home decor. The silicone is very flexible, so your motifs come out of the mould more easily.

According to Cernit, the mould was developed specifically for modelling clays. It is oven-safe, washable and reusable. With a diameter of approx. 7 cm and a height of 1 cm, it is easy to handle and can be stored neatly by its hanger.

Working with the mould

Press the modelling clay firmly into the cavity so that fine edges are also shaped, and smooth off any excess clay. To demould, flex the silicone slightly and push the motif out from the back rather than pulling on the clay. With epoxy resin, fill the mould following the resin instructions and demould only once it has fully cured.

Care and notes

You can wash the mould and use it again and again. Once you have used it for modelling clay or resin, do not use it for food any more.

Cernit Cloud Silicone Mould product details

• Manufacturer: Cernit, art. no. CE95117C
• Motif: clouds
• Material: silicone, white
• Diameter: approx. 7 cm
• Height: 1 cm
• Suitable for: polymer clay, epoxy resin
• Oven-safe, washable, reusable
• With hanger
• Not for food contact

You will also need: polymer clay (e.g. Cernit) or epoxy resin of your choice and, depending on the clay, an oven and a baking surface

Not suitable for food. Not a toy; intended for adults.